Page 11
For technical questions, please call 1-888-866-5797.
Item 62811
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Installing collared chisel (Sold Separately)
Note:
Keep shank clean. Do not lay in dirt or dust.
1.
IMpORTANT!
Clean shank with cloth, then
lubricate using included Chisel Grease.
2. Move Chisel Lock to unlocked position.
3. Slide Chisel in as far as it will go.
chisel
Lock
chisel
Figure D: Unlocked position
4. Move Chisel Lock to locked position.
Figure E
Note:
The Chisel will have play, but
should not come out when pulled.
Work Area Set Up
1. Make sure the work area is well-lit.
Keep children
and bystanders a safe distance from work area.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
General Operating Instructions
NOTE:
If the Carbon Brush Light comes on and
Breaker Hammer stops operating,
see carbon Brush
Replacement and Lubrication on page 12.
1. Make sure that the Power Switch is in
the OFF (O) position, then plug Breaker
Hammer into dedicated 120V outlet.
2. Set the end of Chisel against the work surface.
WARNING!
Do not press forcibly against
the work surface. Hold the Breaker Hammer
with just enough pressure so that the tool’s
own weight supplies the needed force.
3. Place one hand on the Main Handle and the other
hand on the Side Handle, gripping them firmly.
4. Press the Power Switch to ON (I) position.
The power light will come on and the
Breaker Hammer will begin operating.
NOTIcE:
To prevent damage to the
Breaker Hammer, do not operate without
the Chisel against the work surface.
5. When done, Press the Power Switch to OFF (O)
position, then unplug Breaker Hammer.
cAUTION!
chisel may be HOT after use.
Avoid contact with skin; use heavy-duty
protective gloves when removing chisel.
6. Remove Chisel, clean Chisel and Hammer,
then store indoors out of children’s reach.
Note:
Store where temperature is no lower than 50° F.
