3
1 2
1.GND
2.
3.
+
-
O
6. Slide the transmitter's AUDIO ON / OFF switch to ON position.
7. Speak in the normal conversational voice. Proper operation is indicated by :
Steady glow of the receiver's DIVERSITY A / B lights and RF indicator.
Flickering of the receiver's AF indicator light when you speak into the mike.
8. During the pause of presentation, slide the Audio ON / OFF switch to OFF position.
9. When the presentation is over, turn off the sound system and turn off the transmitter power.
Operating the Headset System
1.Refer to Fig.5 below, insert the cable into the cable restraint, connect the AC power adaptor
to the DC IN connector on the back of the receiver. Plug the adaptor into an AC wall socket.
Push to switch on the receiver. The LCD on the receiver will glow.
2.Raise the antennas and point away from each other at a 45 angle from vertical to achieve
optimum reception.
3.Connect the receiver's Balanced or Unbalanced AUDIO OUT connector to the mixer input
using an XLR to XLR audio cable or 1/4" to 1/4" phone plug cable. Set the receiver's output to
match the sound system's input.
4.Adjust headband and place the headset on head, and keep it approximately 1/2" from side
of the mouth.
5.Plug the connector ( mini XLR or phone plug ) of the headset microphone into the beltpack
transmitter connector input. Press the power on / off switch to switch on the transmitter. The
transmitter's red LED will flash and the receiver's red DIVERSITY A/B lights will glow.
6.Slide the transmitter's AUDIO ON / OFF switch to ON position.
7.Speak in normal conversational voice. Proper operation is indicated by :
Steady glow of the receiver's DIVERSITY A / B lights and RF indicator.
Flickering of the receiver's AF indicator light when you speak into the mike.
8.During the pause of the presentation, slide the Audio ON / OFF switch to OFF position.
9.When the presentation is over, turn off the sound system and turn off the transmitter power.
3
1 2
1.GND
2.
3.
+
-
Fig.4
Fig.5
10
19
20
16
17
18
1. Power switch
2. Diversity A B
3. RF indicator
4. AF indicator
5. LCD
6. UP button
7. DOWN button
8. MENU
9. SET
10. Mic-battery weak indicator
11. Antenna B (TNC socket)
12. CH2 Unbalanced AF out
13. CH2 Balanced AF out
14. CH2 Squelch control
15. DC in
16. CH1 Unbalanced AF out
17. CH1 Balanced AF out
18. CH1 Squelch control
19. AC in
20. Antenna A ( TNC socket )
10
Front
Rear
Parts and functions of SDR-8200 receiver
3
12
