Cheyenne PU 1, Руководство пользователя

Страница: 13 / 20

MT.DERM GmbH
WWW.CHEYENNE-TATTOO.COM
13
3 Important hygiene and safety instructions
The control unit must be wiped with a soft cloth that has been moistened with a mild soap solution. If
necessary use a mild disinfectant, for example 70% water-2-propanol solution.
The handpiece as well as the handpiece storage equipment must be cleaned immediately before use
or before the treatment by wiping over said objects with a soft cloth that has been soaked with disin-
fectant and cleaning agent. The handpiece and the control unit are not allowed to ever be soaked in
disinfectants as otherwise internal parts might start corroding. Before use the control unit, the hand-
piece, the handpiece cable as well as the handpiece storage equipment must be covered with a pro-
tective cloth or sheet or with a protective sleeve or tube.
The tattooing must take place in a clean room where smoking is forbidden. With regard to this,
please observe the local regulations on the layout and organisation of workplaces.
4 Operation
4.1 Device set-up
The control units PU I and PU II are to be used indoors. They can be operated without any problems
in room temperatures ranging from 10°C to 35°C. Before the start of operation it should be ensured
that the device has adjusted to the room temperature as otherwise the condensate that is created could
damage the electronics (when there is a temperature difference of 10°C or more then please wait at
least three hours).
The device is designed as a tabletop unit; that means it is to be set up on a clean, stable and level
base or support.
4.2 Device connection
First the foot-operated switch is connected to the socket (8) at the back of the device. After this, the
handpiece is connected to the sockets (10) and (11) (with the PU I only one handpiece can be conect-
ed) on the underside of the control unit. The configuration of the sockets is in accordance with the
selection switch for the handpieces at the front side of the device.
The final step is to connect the power supply unit plug to the control unit. The device is only allowed
to be operated with the power supplies unit plug that is displayed on the type plate of the device. The
power supply voltage must be the same as the stated nominal voltage of the device which is on the
label of the power supply unit plug!
The socket (9) designed for this can also be found on the rear side of the control unit. After the pow-
er supply unit plug has been connected to the power supply voltage, the red “Power” LED goes on.