Chevrolet Silverado Classic 2007, Руководство пользователя

Страница: 528 / 676

Rear Axle
When to Check Lubricant
It is not necessary to regularly check rear axle
fluid unless you suspect there is a leak or you hear
an unusual noise. A fluid loss could indicate a
problem. Have it inspected and repaired.
All axle assemblies are filled by volume of fluid
during production. They are not filled to reach
a certain level. When checking the fluid level on
any axle, variations in the readings can be caused
by factory fill differences between the minimum
and the maximum fluid volume. Also, if a vehicle
has just been driven before checking the fluid
level, it may appear lower than normal because
fluid has traveled out along the axle tubes and has
not drained back to the sump area. Therefore, a
reading taken five minutes after the vehicle
has been driven will appear to have a lower fluid
level than a vehicle that has been stationary
for an hour or two. Remember that the rear axle
assembly must be supported to get a true reading.
How to Check Lubricant
To get an accurate reading, the vehicle should be
on a level surface.
•
The proper level for the 1500 Series is from
5/8 inch to 1 5/8 inch (15 mm to 40 mm)
below the bottom of the filler plug hole.
•
The proper level for the 1500HD Series,
2500 Series and 2500HD Series with the 6.0L
V8 engine (RPO LQ4) is from 0 to 1/2 inch (0 to
13 mm) below the bottom of the filler plug hole.
1500 Series Shown, 2500 Series Similar
528