Chevrolet GMC 2002, Дополнение к руководству пользователя, Страница: 43 / 65

6-14
9. Remove the shipping plug from the bottom of the
new filter.
10. Using the seal that comes with the new filter, install the
original water drain valve assembly on the new filter.
Tighten the valve by hand, but do not over
-
tighten.
11. Align the widest key on the top of the filter element
with the widest slot on the filter housing and push
the element in until the mating surfaces touch.
The arrow on the filter element should be aligned
with the air purge valve.
12. Reinstall and tighten the ring nut until the
alignment arrow on the ring nut aligns with the
arrow on the filter. A click should be heard when
the ring nut snaps into the locked position.
13. Connect the water sensor electrical connector
to the water sensor on the bottom of the filter.
Be sure the connector boot is sealed to the bottom
of the drain cap.
14. Attach a 5/16 inch inside diameter hose to
the air bleed valve and lead hose into a
fuel
-
resistant container.
15. With the air bleed valve still open, turn the ignition
key to START for 10 to 15 seconds. Wait one
minute for the starter to cool. Do this until you
can see clear fuel coming out of the air bleed valve.
If no liquid comes out, your vehicle needs service.
16. Close the air bleed valve, remove the hose and
install the fuel cap.
17. Reinstall the protective shield and bolts.
18. Start the engine and let it idle for five minutes.
Check your fuel filter and air bleed valve for leaks.