Chevrolet City Express 2018, Руководство пользователя

Страница: 155 / 287

Chevrolet City Express Owner Manual (GMNA-Localizing-U.S./Canada-
11683523) - 2018 - CRC - 7/10/17
154 Driving and Operating
Each time the engine is started,
or when the shift lever is shifted to
any position other than D (Drive),
the Overdrive off mode will be
automatically turned off.
Accelerator Downshift in D
Position
For passing or hill climbing, press
the accelerator pedal to the floor.
This shifts the transmission down
into a lower gear, depending on the
vehicle speed.
High Fluid Temperature
Protection Mode
If the fluid temperature becomes too
high from climbing a steep grade in
high temperatures, such as towing a
trailer. Engine power and vehicle
speed will be decreased
automatically to reduce the chance
of transmission damage. Vehicle
speed can be controlled with the
accelerator pedal but the engine
and vehicle speed may be limited.
Fail Safe
When the fail-safe operation occurs,
the CVT will not be shifted into the
selected driving position.
If the vehicle is driven under
extreme conditions, such as
excessive wheel spinning and
subsequent hard braking, the
fail-safe system may be activated.
The malfunction indicator lamp may
come on to indicate the fail-safe
mode is activated. See
Malfunction
Indicator Lamp (Check Engine
Light)
0 91 . This will occur even if all
electrical circuits are functioning
properly. In this case, place the
ignition switch in the OFF position
and wait for 10 seconds. Then place
the ignition switch back in the ON
position. The vehicle should return
to its normal operating condition. If it
does not return to its normal
operating condition, have a dealer
check the transmission and repair if
necessary.
{
Warning
When the high fluid temperature
protection mode or fail-safe
operation occurs, vehicle speed
may be gradually reduced. The
reduced speed may be lower than
other traffic, which could increase
the chance of a collision. Be
especially careful when driving.
If necessary, pull to the side of
the road at a safe place and allow
the transmission to return to
normal operation, or have it
repaired if necessary.