Black plate (25,1)
Chevrolet Impala Owner Manual - 2013 - crc - 8/27/12
Vehicle Care
10-25
To replace one of these bulbs:
1. Open the trunk. See
Trunk on
page 2
‑
9
.
2. Remove the convenience net (if
equipped). Unhook the net from
the upper wing nut.
3. Turn the upper wing nut
counterclockwise and remove it.
4. Pull the carpet away from the
rear of the vehicle.
5. Turn the two hex nuts
counterclockwise to
remove them.
6. Pull out the taillamp assembly
and disconnect the wiring
harness.
7. Turn the bulb socket
counterclockwise to remove it.
8. Pull the old bulb straight out to
remove it.
9. Push the new bulb straight in
until it clicks to install it.
10. Reverse steps 1 through 7 to
reinstall.
License Plate Lamp
To replace one of these bulbs:
1. Remove the two screws (A) from
the license plate lamp assembly.
2. Pull the lamp assembly down
and turn the bulb socket
counterclockwise and out of the
lamp assembly.
3. Pull the old bulb straight out of
the socket.
4. Install the new bulb.
5. Reverse Steps 1 through 3 to
reinstall the license plate lamp
assembly.