Chevrolet 2011 DURAMAX Diesel, Руководство пользователя

Страница: 29 / 134

Black plate (3,1)
DURAMAX Diesel Engine (LML/LGH) - 2011
Driving and Operating 9-3
If the Diesel Engine Will Not
Start
If you have run out of fuel, see
Running Out of Fuel on page 9 ‑ 32 .
If the vehicle is not out of fuel, and
the engine will not start, do this:
Turn the ignition key to ON/RUN.
Immediately after the wait to start
light goes off, turn the ignition key
to START.
If the light does not go off, wait a
few seconds, then try starting the
engine again. See your dealer as
soon as you can for a starting
system check.
If the light comes on and then goes
off and you know the batteries are
charged, but the engine still will not
start, the vehicle needs service.
If the light does not come on when
the engine is cold, the vehicle
needs service.
If the batteries don't have enough
charge to start the engine, see
“ Battery ” in the Index of the vehicle
owner manual.
Be sure you have the right oil for the
engine, and that you have changed
the oil at the proper times. If you
use the wrong oil, the engine may
be harder to start.
Be sure you are using the proper
fuel for existing weather conditions.
See
Fuel for Diesel Engines on
page 9 ‑ 17 .
If the engine starts, runs a short
time, then stops, the vehicle needs
service.
{
WARNING
Do not use gasoline or starting
aids, such as ether, in the air
intake. They could damage the
engine. There could also be a
fire, which could cause serious
personal injury.
Elevated Idle
The engine has a cold temperature
high idle feature which elevates the
engine idle speed from base idle
to 1050 rpm for pickup models or
1200 rpm for van models when
outside temperatures are below
0°C (32°F), and the engine coolant
temperature is below 65°C (150°F).
This feature enhances heater
performance by raising the engine
coolant temperature faster.
This feature can be turned on or off
using the DIC buttons. If the vehicle
is not equipped with DIC buttons, do
the following to turn this feature on
or off:
1. Turn the ignition to ON/RUN,
with the vehicle off.
2. Press the accelerator pedal to
the floor and hold while quickly
pressing the brake pedal three
times in less than eight seconds.
3. Release the accelerator pedal
and start the engine.