CHESHIRE MOULDINGS axxys evolution, Инструкция по монтажу

Страница: 8 / 12

axxys
®
evolution
fitting instructions
90 o Elbow for
Return Landings
Please Note;
When using a combination of
the 90
o
Elbow (AXLQT) and the
Landing Handrail Connector
(AXEVLHC) to form a return landing,
the minimum distance you can
achieve is 140mm from the centre
of the staircase baserail to the
centre of the landing baserail.
If you have a return landing,
then our 90
o Elbow (AXLQT)
can be used to achieve this,
in conjunction with a Landing
Handrail Connector (AXEVLHC)
and short piece of handrail.
Simply mitre the handrails using the
template supplied (found at the back of
this booklet), slide them into the elbow
from either side and check that the
handrails pass the screw holes. Then
pre drill and secure the handrails using
the four screws supplied and glue from
underneath (fig. 13).
Lie the assembly on top of the baserail
and behind the newel, then measure
the cut off point for the short piece
of handrail against the newel face,
remembering to include the connector
tolerance and to ensure the handrail is
in line with the baserail. Cut the handrail
at the point you have just marked.
Now slide the short handrail end into
the Landing Handrail Connector, and
secure using the two 30mm screws
provided. The completed assembly
should look like the illustration to the left
(fig. 14).
www.axxys.co.uk