Chery QQ3, Руководство пользователя

Страница: 23 / 184

Notices Before Drive
14
Activating door Lock and
Burglarproof Mode

Close all the windows;

Turn ignition key to B, and pull
out the key;

Let all passengers get off the car.

Close all doors and hoods and
trunk lid.

Press down the LOCK button on
the sensor so as to lock all of the
doors. Those cars equipped with
power window
lifting system will
automatically raise all windows,
and at the same time hazard
warning lamp glitters 3 times and
the burglarproof mode is started.

If the ignition switch is set on II,
the burglarproof mode does not
work but the function of locking
still work normally.
！
Notice
If you use key to lock the door, the
burglarproof mode can not be activated.
Please use sensor if you want to activate
that mode.
Relief of Door Lock and
Burglarproof Mode
Press UNLOCK button on the sensor
to unlock all doors and hazard
warning lamp glitters twice at the same
time, burglarproof mode is exited.
Normal status: If there is not
interruption and fault, hazard-warning
lamp will glitter twice, and the interval
between each glitter is 0.5 sec.
Replace Sensor Battery:
Sensor indicator lamp does not glitter,
which means that battery needs to be
replaced, but sensor can still be used for a
period of time.
Replace a Panasonic CR2032 battery (or
other equivalent 3V battery) in following
process:

Insert a screwdriver into the gap
between the sensor cover and
separate the 2 covers of the sensor.

Insert a screwdriver into the gap
between the sensor covers and
separate them.

Pull the sensor power supply out of
the cover and disconnect the
attachments carefully and p ut it at a
clean p lace.

Install new battery, make sure that
the polarity is correctly placed
(cathode facing bottom)

Install the attachments and put the
sensor power supply into the cover.

Close the two covers of sensor.

Check whether the sensor can work
properly.
！
Notice
The waste Li-battery will do harm to the
Accumu
Battery