Chery Karry, Руководство пользователя, Страница: 83 / 131

Emergency Procedures
83
Remove the wheel
1. Make sure the vehicle is placed on a
stable, level ground and front wheels
facing to the right ahead.
2. Turn off the ignition switch.
3. Please select the P position for the
transmission.
4. Tell passengers to leave the vehicle.
5. Use proper wheel stopper to secure
the vehicle in order to avoid rolling
or sliding if necessary.
6. Insert the flat screwdriver in the gap
between the steel ring and hub cap,
then carefully turn it and remove the
hub cap.
7. Use special tool to unscrew the
wheel nuts as shown in the figure
below.
8. Place the jack and ensure the whole
seat located on a solid ground.
9. The jack must vertically lift up to the
jack lift point.
10. Lift up the vehicle until the wheel
departures from the ground.
11. Remove the wheel nuts and then
take out the wheel.
Install the wheel
1. Push the wheel to the rim bolt,
tighten the wheel nut clockwise and
make sure the wheel nut tip facing to
the wheel.
2. Lower the vehicle and remove the
jack.
3. Use the diagonal tightening method
to fully tighten wheel nut in two or
three times (Tightening torque:
110±10N•M).
4. Steadily press the hub cap by both
hands.
5. Collect the jack and fault wheel in
reverse order and fasten them.
6. Do best to send them to the Chery’s
special service station to check the
tightening torque of wheel nuts and
tire pressure.
7. Because the spare wheel may not be
used for a long time, please charge
the tire with pressure slightly higher
than the normal tire pressure in order
to keep standard tire pressure of the
spare tire.