27
The clamp allows to fix the motor directly on the side-cover bolt
(Ø 12 mm).
The clamp may be used only for motors until maximal torque of
15 Nm.
INSTRUCTION FIXING WITH CLAMP
The bolt has to be in aluminum
with minimal Ø 11,5 and maximal Ø 11,9 mm.
Close the screw using an hexagonal key 5 mm.
Closing torque
minimal 9 Nm maximal 11 Nm
, by keeping the motor as near as
possible to the sidecover.
The clamp is supplied pre-assembled with the tightening of the screw on right
side, in case should be necessary to tighten the screw on the left side go on as
follows:
- remove the screw
- remove the plate
- remove the clamp and reinsert it upside down
- insert the screw from the left side.
2
3
1
1
3
2
E
NG
L
IS
H
