TOOL CAPACITY CHART:
The numbers shown in the rivet columns below are the maximum grip
length that can be installed with this tool. Dashes indicate sizes which cannot be installed in any grip
length.
CHERRY
RIVETER
MODEL
M S S T Y L E C H E R R Y R I V E T S
( M S 2 0 6 0 0 )
SELF-PLUGGING PULL-THROUGH
ALUM. MONEL
ALUM.
STEEL
MONEL
9157
9163
9156
9162
9 5 6 3 9562
9117
9127
9116
9126
9517
9516
SERRATED
STEM
PULLING
HEAD
RIVET
DIAM.
*
UNIV.
HEAD
CTSK.
HEAD
UNIV
HEAD
CTSK.
HEAD
UNIV.
HEAD
CTSK.
HEAD
UNIV.
HEAD
CTSK
HEAD
-4 ALL
ALL
ALL ALL ALL ALL ALL ALL
-5 ALL
ALL
-
-
ALL ALL
-
-
-6 16
18
-
-
-
-
-
-
G715A
H9015
-8 -
-
* Rivet diameters shown apply to either knob or serrated stem rivets. Grip lengths shown apply only to knob stem since all lengths of serrated stem rivets can
be installed by cycling tool as many times as necessary.
MAINTENANCE AND REPAIR
The G715A Riveter has been manufactured
to give maximum service with minimum care.
In order that this may be accomplished, the
following recommendations should be
followed.
1.
The hydraulic system should be full of oil
and free from air at all times.
2.
Keep excessive moisture and dirt out of the
air supply to prevent wear.
3.
Do not pound on the rear of the tool head to
force rivets into holes as this will damage
the tool.
4.
Make sure the pulling head is correctly and
securely attached.
TO FILL RIVETER WITH OIL
1.
Connect the tool to an air line and remove
the cap screw (5) located on the side of the
head.
2.
Using a pressure oil can filled with DEXRON
III Automatic Transmission Fluid, Type A (no
substitute), force the fluid into the head until
filled. It may be necessary to turn tool upside
down to insure head is filled with fluid.
3.
Replace the cap screw, cycle the trigger
several times and then repeat steps 1 and 2
above.
4.
To insure the positive removal of ALL air from
the hydraulic system, we recommend the
use of Cherry Air Bleeder No. 700A77.
