Chelsio Communications Terminator Series, Инструкция по установке и эксплуатации, Страница: 49 / 54

Chapter II. FCoE Storport Miniport
Chelsio Unified Wire for Windows 49
vii. The volume should appear in My Computer .
Figure 18 - The newly created volume in My Computer
Troubleshooting
i.
Always enable LLDP on the interfaces as there won’t be FCoE link up until and unless a
successful LLDP negotiation happens.
ii. On switch, make sure priority-flow-control mode is always set to auto and flowcontrol is
disabled.
iii. Always configure the Ethernet interfaces on cisco switch in trunk mode.
iv. If you are binding the VFC to MAC address in case of cisco nexus, then make sure you
make the Ethernet interface part of both Ethernet VLAN and FCoE VLAN.
v. If in any case the switch-port on the cisco nexus switch is reporting
“pauseRateLimitErrDisable”, then perform an Ethernet port shut/no shut.
Also, note that only one FCoE function will be displayed under the storage controllers of the
device manager, irrespective of the number of ports a card possesses. All ports will be using the
same interface.