Chelsio Communications Terminator Series, Инструкция по установке и эксплуатации, Страница: 45 / 54

Chapter II. FCoE Storport Miniport
Chelsio Unified Wire for Windows 45
iv. On the FC Ports, if a FC target is connected then perform the following steps -
Switch(config)#vsan database
Switch(config-vsan-db)#vsan 2
Switch(config-vsan-db)# vsan 2 interface fc 2/2
Switch(config-vsan-db)#exit
Switch(config)interface fc 2/2
Switch(config-if)# switchport mode auto
Switch(config-if)# switchport speed auto
Switch(config-if)# no shutdown.
v. If you have not created a zone then make sure the default-zone permits the VSAN created,
otherwise the initiator and the target on that particular VSAN although FLOGI’d into the
switch will not talk to each other. To enable it, execute the below command.
Switch(config)# zone default-zone permit vsan 2
2.2. FCoE fabric discovery verification
Verifying Target Discovery
To check the summary of targets being discovered from FCoE ports, open device manger and
follow the steps given below:
i. Go to Start -> Control Panel -> Device Manager or launch device manager directly from
Start -> Run -> devmgmt.msc and hit [Enter].
ii. Go to Disk drives section under which you will find the list of all the LUNS that were
discovered.
Figure 11 - Discovered Target LUNs