Maintenance instructions
Section 7A
Unplug the product or turn off the switch before commencing maintenance works on the product.
Aluminium filter cleaning:
Aluminium filter is used to trap the oil particles in the air, therefore it is blocked based on the frequency of
use and leads to performance loss with the product. Accumulated grease layer poses a risk of catching fire.
Therefore, we recommend you to clean your filter once in two weeks. For cleaning, remove the filters as
shown in Figure A9, wash with liquid detergent, rinse with water and reinsert after drying. Do not use acidic,
corrosive cleaning agents for cleaning the filters. Do not start the product without reinserting the filter. The
colour of the filters may change as they are cleaned. This is normal and does not indicate the requirement
of filter replacement. We do not recommend you to clean your aluminium filter in dishwasher. If the
aluminium filter cannot be cleaned, you can buy a new one from the authorized technical service.
Aluminium filter removal:
Figure
A8
Press the aluminium filter lock and remove by
pulling down.
Aluminium filter placement
Place the rear tabs of the aluminium filter in the filter
holders in the rear side of the range, and then press
the filter lock and push the filter up and place the
filter in parallel position to the ground level in order to
inset into the filter channel and release the lock.
Halogen lamp replacement:
Lamp holder:
G4 Halogen lamp
Lamp glass holder
Lamp glass
Figure
A9
- Unplug the product and turn off the relevant fuse switch.
- Remove the middle glass holder by using a thin blade screwdriver as shown in the figure.
- Turn the halogen lamp in the arrow direction, pull and remove the lamp and replace
with the
new one.
- Inset the middle holder by pressing the tabs.
- Connect to the electricity and check whether it functions properly.
10
