12
normal maintEnancE
No
lubrication is required for any moving parts,
motor, bearings or sharpening surfaces. There
is no need for water on abrasives. The exterior
of the sharpener may be cleaned by carefully
wiping with a damp cloth. Do not use detergents
or abrasives.
Once a year or so, as needed, you can remove
metal dust that will accumulate inside the
sharpener from repeated sharpenings. Remove
the small rectangular clean-out cover (figure
14) that covers an opening on the underside of
the sharpener. You will find metal particles adhered to a magnet attached to the inside of that
cover. Simply rub off or brush off accumulated filings from the magnet with a paper towel or tooth
brush and reinsert the cover in the opening. If larger amounts of metal dust have been created or
if the Stage 3 disk has been cleaned (using the cleaning/dressing means), you can shake out any
remaining dust through the bottom opening when the cover is removed. After cleaning, replace the
cover securely with its magnet in place.
sErVicE
In the event post-warranty service is needed, return your sharpener to EdgeCraft where the cost
of repair can be estimated before the repair is undertaken. Outside the USA, contact your retailer
or national distributor.
Please include your return address, daytime telephone number and a brief description of the
problem or damage on a separate sheet inside the box. Retain a shipping receipt as evidence of
shipment and as your protection against loss in shipment.
Engineered and assembled in the U.S.A.
www.chefschoice.com
This product may be covered by one or more EdgeCraft patents and/or patents pending as marked on
the product.
Chef’sChoice
®
, EdgeCraft
®
and Diamond Hone
®
are registered trademarks of EdgeCraft Corporation,
Avondale, PA.
Conforms to UL Std. 982 Certified to CAN/CSA Std. C22.2 No. 64
Certified to EN 60335-1, EN 60335-2, EN 55014-1+A1, EN 61000-3-2, EN 61000-3-3
© EdgeCraft Corporation 2012
E12
C128217
EdgeCraft Corporation
825 Southwood Road, Avondale, PA 19311 U.S.A.
Customer Service (800) 342-3255 or 610-268-0500
Figure 14. Clean-out cover.
