6
When transporting it make sure that it is firmly held by the four corners
(keeping it pa-
rallel to the floor
).
All operations must be carried out by speciali-
zed personnel (Fig. n°9).
WARNING!
2.1 - UNPACKING
Remove the straps from the package (Fig. n°
10) and lift the cardboard (h).
The package should be:
a) the machine on the pallet (Fig. n°11 detail
a);
b) blade extractor (Fig. n°11 detail e);
c) 4 feet (Fig. n°11 detail f);
d) Case, if present (Fig. n°11 detail b).
Check inside the suitcase if it present, find
the following components:
(Fig. n°11):
1. Instruction booklet (detail d) ;
2.
CE
compliance certificate (detail c);
3. Audio-visual
cassette;
4. Liquid detergent with sprayer;
5. Oil
tube;
6. Sharpening and burring grinders;
7. Socket wrench to remove grinders;
8. Grinders
brush;
9. Large and small screwdrivers;
10. Pliers.
CHAP. 2 - INSTALLATION
Fig. n°9
Fig. n°10
h
a
b
Fig. n°11
c
d
e
f
19
CHAP. 6 - ROUTINE CLEANING
6.1 - GENERALITIES
Cleaning the machine must be carried out at least once a day or, if necessary, more fre-
quently .
All the parts of the slicer that come in direct or indirect contact with the food to be cut must
be scrupulously cleaned.
The slicer must not be cleaned with water cleaning machines or water jets, but with the pro-
duct provided and/or with neutral detergents (pH 7).
The use of any other detergent is
prohibited.
Utensils, brushes and whatever else could damage the machine surface must
not be used.
Before carrying out any cleaning operation it is necessary to:
1. disconnect the plug from the electrical network to completely isolate the machine from
the rest of the system;
2. Bring the graduated handgrip which regulates the thickness gauge to “0”.
WARNING: Be careful of residual risks from sharp and/or pointed parts.
6.2 -
CLEANING THE MACHINE
6.2.1 - Cleaning the goods holder plate
The trolley (plate + arm + stem) is easily
transportable:
-
bring the graduated handgrip to
“0” (1 Fig. n°46);
-
bring the trolley (2) to the end of its run (a)
from the controls side; partially unscrew
the plate lock handgrip (3), pull the trolley
towards the operator; completely unscrew
the plate lock handgrip, therefore lift the
trolley up (b - Fig. n°46);
-
having taken off the trolley, the goods
holder plate can be carefully cleaned with
warm water, the equipped detergent or
neutral detergent (pH 7) Fig. n°47.
6.2.2 - Cleaning the blade, the blabe
cover and the ring
WARNING: a pair of metallic gloves must
be worn while cleaning the blade (1) (Fig.
n°48) ed utilizzando un panno umido.and
a damp cloth must be used.
Unscrew the handgrip from the bladecover tie
rod (1) and extract the bladecover (2) using
the proper grip to hold it (Fig. n°48). At this
point it is possible to clean the blade a Fig. n°
49.
To clean the surfaces opposite the
blade and the ring, the blade must be
extracted in the following way:
Fig. n°46
1
a
3
b
2
pH
Fig. n°47
Fig. n°48
3
2
1
