3
4
RJ11-17-CTI
RJ11-17-CTI
FIRST TIME USE
1.
Pull out power cord from the compartment under the base, place base on a flat surface.
2. Open the lid then fill water into the kettle.
3. Fill kettle to the maximum level mark with fresh tap water.
4. Close the lid and place the kettle back on the base unit, and plug into a power outlet.
5. Switch the kettle on by pressing the Power button, the red LED light inside the glass kettle
will illuminate to indicate the water is heating to boiling.
6. The kettle will automatically shut off once the water has boiled and the red LED indicator
light has gone off.
NOTE
: Wait 30–60 seconds if you need to refill and reboil again heat the
water immediately after a boiling cycle.
7. After automatic shut off, unit will stay in the Keep Warm setting for 30 minutes, keeping the
unit at set temperature.
8. Empty the kettle then wash with water, repeat the above 2 times.
NOTE
: Never allow the water to fill above the maximum level or lower than the minimum level
indicated on the glass kettle.
MAKING TEA
1.
Remove tea infuser from kettle by grasping the tea infuser insert and lifting up.
2. Add fresh, cold water to the kettle, filling it for the number of cups of tea you wish to make—
about 8 cups (1.8 liters).
3. Insert tea infuser into the kettle and ensure it is securely in place.
4. Once water has boiled, open lid and carefully add tea leaves or tea bags to the tea infuser.
Securely close the lid. Warning: Use extreme caution when adding tea leaves or tea bags as
kettle will be very hot.
5.
CAUTION
:
Wait until unit has completely cooled before removing tea infuser.
Tea infuser will be very hot after use; may cause serious burns if not handled properly.
SELECTING PRESETS
1.
Push Power button to turn on ketttle. Kettle will automatically light up with red default LED
setting, indicating the unit is boiling the water.
2. Press the Temperature button to toggle through the 5 presets:
Green - 175˚F
Blue - 185˚F
Yellow - 195˚F
Purple - 200˚F
Red (default) - 212˚F
NOTE
: The power source will only work if the kettle is placed directly on the
power base.
OPERATING INSTRUCTIONS
FEATURES
1
1.
Tea Infuser
2.
Lid Release Button
3.
Tea Infuser Mount
4.
Removable Spout Filter
5.
Control Panel
5a.
Power Button turns unit on and off
5b.
Temperature Button select
temperature for each variety of tea
• Green LED - Green (175°F)
• Blue LED - White (185°F)
• Yellow LED - Oolong (195°F)
• Purple LED - French Press (200°F)
• Red LED - Herbal (212°F)
• Red LED - Black (212°F)
6.
Glass Kettle with easy-to-read water
level markings
7.
Stay-Cool Handle
8.
Power Base with 360° swivel
3
4
6
2
7
8
5a
5b
5
