Check Point Quantum Spark 1570R, Руководство по началу работы

Страница: 10 / 78

Setting up the Appliance
Quantum Spark 1570R Appliance R80.20.XX Getting Started Guide | 10
Setting up the Appliance
1. Remove the Quantum Spark 1570R appliance from the shipping carton and place it on a tabletop.
For other mounting options, see below.
2. Identify the network interface marked as LAN1. This interface is pre-configured with the IP address
192.168.1.1
.
Mounting Options
n
Desktop - No special hardware or mounting instructions necessary. Assemble the 4 rubber feet (as
part of the box accessory kit) on the marked locations on the bottom side of the 1570R Appliance.
n
DIN rail kit (complies with IEC61850-3 class 0) as part of the box accessory kit – Attaches to either
back panel (for 1570R Wired) or bottom panel (for 1570R Wired and Wired-LTE).
The DIN rail is supported on the bottom side for both flavors and on the rear side for the 1570R wired
flavor.
n
Wall mount - Attached from bottom panel. Use the sticker included in the box and the 2 screws and
anchors. (as part of the box accessory kit).
n
Wall mount brackets (comply with IEC60068-2-27, severity level 30g/11ms, IEC61850-3 Class 2) - 2
side brackets from the bottom side of the 1570R (Wired and WiFi-LTE). It is sold separately as a FRU.
Note - For Maritime installations, use only the wall mount brackets.
This table presents the dimensions of the 1570R Appliance with the DIN adapter of the Wired and Wireless.
Use this to design the required space for the appliance.
Flavor
Height
(mm)
Width
(mm)
Depth
(mm)
Notes
1570R
Wired
90 150 150 Without rubber feet
1570R with
rear DIN
adapter 90 150 168
1570R with
bottom DIN
adapter 108 150 150
1570WLE
with rear DIN
adapter
WiFi-LTE
177 150 225 Includes the LTE and WiFi antennas.
For that setup, a middle-part adapter
is required between the DIN adapter
and the 1570R Appliance.
1570WLE
with bottom
DIN adapter 195 150 225 Includes the LTE and WiFi antennas.