©2010 Check Point Software Technologies Ltd. All rights reserved.
Classification: [Unrestricted] — For everyone | P.
8
6. From the side of the rack, tighten the 4 hex nuts (A) that were used to partially secure
the brackets to the rails. (See alternate procedure on next page if access to the side of
the rack is not possible.)
Installing the Outer Rail – Alternate Procedure.
1. If access to the side of the rack is not possible, then the installer must first pre-measure
the depth of the rack from front to back.
2. On the bench, extend the rails to the measured depth and tighten the 4 nuts used to
attach the rail brackets to the rails.
3. Using the 4 x screw/washer pairs, attach the rail to the rack as described on previous
page.
4. Repeat Steps 1-3 for attaching the 2nd outer rail to other side of rack.
Pre-measure inside
depth of rack
