©2010 Check Point Software Technologies Ltd. All rights reserved.
Classification: [Unrestricted] — For everyone | P.
6
Installing the Outer Rail
1. Install the front of the outer rail to the rack, using the screw/washer pairs shown. (Note:
the front of the rail is the side where the middle rail can extend out from.) Do not
completely tighten these front screws. Leave them loose enough to allow adjusting the
bracket position so that the middle rail can slide out the front smoothly. Once positioned
properly, the screws can be tightened.
Repeat installation of screw/nut pair for 2
nd
hole for
bracket.
Repeat the procedures on the previous pages for
mounting the 2 rail brackets to the second slide rail
Ensure that the middle rail slides smoothly out
the front of the rack, before tightening the rail
bracket to the rack.
