![Check corporation 2 Series Скачать руководство пользователя страница 7](http://html.mh-extra.com/html/check-corporation/2-series/2-series_installation-instructions-manual_2594790007.webp)
Page 7
2 Series Carbon Fiber Seat Heater
M
ANUFACTURED
IN
M
ICHIGAN
! USA
Safety:
PLEASE READ BEFORE INSTALLING HEATING ELEMENT ASSEMBLIES!
Do not modify this product.
Do not connect this product to factory seat heater parts
Check Corporation wire heating element assemblies are specific to each seat and are not to
be cut. They are designed to fit specific vehicle seats according to the model and production
year of the vehicle. For a full list of vehicles that your kit is compatible with, please call
customer service at 877-607-8941.
Some front passenger seats are outfitted with occupant detection sensors which are not
compatible with any after-market seat heater. Consult with Check Corporation to determine
the appropriate heating element assembly for each specific vehicle.
Heating elements should NEVER be installed onto foam where an occupant detection
sensor is visible on the Top surface of the foam, even if the heating element would not touch
the sensor. Heating elements are to be placed onto foam bun only. The heating elements
may adversely affect or cause the sensors or airbag system to not function correctly, thereby
causing severe injury or death.
The heating elements must be connected to switched or keyed ignition power only, to
prevent battery drain when vehicle is off.
Check and determine that the heating elements will fit under the seat trim covers in the
desired areas. The listing channels or the Velcro hold-downs should line up with the cutouts in
the heating elements. This is not important if the heating elements do not cross over a listing
channel or Velcro hold-down. See figure 1
BONDED SEATS (UPHOLSTERY GLUED TO FOAM BUN)
Never remove the cover of a bonded seat. The cover of a bonded seat cannot be installed
again once it has been removed. If installation of a heating element assembly is to be
attempted in this kind of seat, cut an opening in the foam bun large enough for the element to
fit ½
″
underneath the cover. A professional should only attempt this, as mistakes often result in
the replacement of the seat foam and cover.
CLOTH UPHOLSTERY
If your upholstery is thin, and does not have at least 1/4” of foam sewn onto the backside of the
upholstery, it is recommended that you apply a 1/4” to 1/2” thick layer of foam or headliner
fabric to the entire insert area between the heating element and the upholstery. This will
eliminate read-through and make sure the temperature is at an appropriate level.