CHD TR2-KBD, Руководство пользователя и инструкция по установке, Страница: 5 / 12

TR2-KBD
MIDI Interface for Korg Trident Keyboard
Model 8-436 ver. 1.0
Copyright © 2018 CHD Elektroservis.
All rights reserved. No part of this publication may be reproduced in any form without the written permission of CHD Elektroservis.
5
2.2 2.2 2.2 2.2 MIDI MIDI MIDI MIDI----IN IN IN IN SOCKET SOCKET SOCKET SOCKET INSTALLATION INSTALLATION INSTALLATION INSTALLATION
There are two possible ways to install the MIDI-IN DIN socket:
If you do not want to mechanically damage the rear panel of the instrument, take out the MIDI cable through
the slot on the left side of the keyboard and solder cable DIN connector on its end (see pic. 2.2-1).
It is better to place the MIDI-In connector on the rear panel of the instrument for easier operation. It is
necessary to drill three holes in the instrument panel however. The MIDI-In connector can be installed near
the jack connectors (see pic. 2.2-2). The MIDI-In connector installation procedure is as follows:
Pic. 2.2 Pic. 2.2 Pic. 2.2 Pic. 2.2----1 11 1 Pic. 2.2 Pic. 2.2 Pic. 2.2 Pic. 2.2----2 22 2
a) Flip the front cover over and return it to its original closed position on top of the synth.
b) Drill three holes in the rear panel as shown on pic. 2.2-3. Work carefully so as to not drill the parts inside the
instrument (pic. 2.2-4).
Pic. 2.2
Pic. 2.2 Pic. 2.2
Pic. 2.2----3
33
3 Pic. 2.2
Pic. 2.2 Pic. 2.2
Pic. 2.2----4
44
4
c) Clean the edge of the holes with small rasp (pic. 2.2-5). Also clean the holes from the inside after the
turning over the front cover.
d) Clean all iron sawdust and raspings from the inside of the instruments Clean all iron sawdust and raspings from the inside of the instruments Clean all iron sawdust and raspings from the inside of the instruments Clean all iron sawdust and raspings from the inside of the instruments, they can cause short circuits or
serious electrical damage if left in the instrument. Please clean the instrument carefully!
e) Get flat connector of MIDI cable through the hole in rear panel into the instrument (pic. 2.2-6).
f) Insert the DIN connector into hole in rear panel (pic. 2.2-7) and fix the connector to the panel. Use two
screws, nuts and washers - parts of the kit (pic. 2.2-8). Hold the nuts with help of pliers for example during the
fixing.