CHD KM500-KBD, Руководство по обслуживанию

Страница: 2 / 4

Korg M500 Interface Korg M500 Interface Korg M500 Interface Korg M500 Interface
KM500 KM500 KM500 KM500----KBD KBD KBD KBD
Service Manual Service Manual Service Manual Service Manual
8 88 8----428 / v. 1.00 428 / v. 1.00 428 / v. 1.00 428 / v. 1.00
Copyright © 2019 CHD Elektroservis. All rights reserved.
No part of this publication may be reproduced in any form without the written permission of CHD Elektroservis.
2
22
2
1 11 1 INTRODUCTION INTRODUCTION INTRODUCTION INTRODUCTION
The KM500-KBD interface includes EEPROM type memory for storing of basic firmware data. Necessary data are
programmed to the memory during the interface manufacturing so you need not to reload the data when the
you need not to reload the data when the you need not to reload the data when the you need not to reload the data when the
new interface is being installed
new interface is being installed new interface is being installed
new interface is being installed. Only when the content of the memory is damaged or when interface’s CPU is
upgraded, you have to load the data to the memory again.
If the memory content is unreadable for the interface’s CPU (it is damaged or it is of different version), the
interface doesn’t work and it indicates fatal error status – indication LED of the interface blinks in yellow
continuously. In that case, execute procedure described in chapter 2.
If the interface’s CPU was replaced with another one with higher software version, it is recommended to adjust
the interface as described in chapter 3.
2 22 2 FIRMWARE DATA LOADING FIRMWARE DATA LOADING FIRMWARE DATA LOADING FIRMWARE DATA LOADING
2.1
2.1 2.1
2.1 PREPARE THE INTERFACE (INSTRUMENT)
PREPARE THE INTERFACE (INSTRUMENT) PREPARE THE INTERFACE (INSTRUMENT)
PREPARE THE INTERFACE (INSTRUMENT)
Figure 1 Figure 1 Figure 1 Figure 1
1. Interconnect the interface with your DAW /
PC bi-directionally (with both MIDI cables –
fig. 1).
2. Insert a jumper to the "TEST" plug head on
the interface board (fig. 2).
3. Plug instrument's power supply cable to a
mains socket and switch the instrument
on. Attention
Attention Attention
Attention ---- work very caref
work very caref work very caref
work very carefully during all
ully during all ully during all
ully during all
next procedures
next procedures next procedures
next procedures ---- there is a risk of electric
there is a risk of electric there is a risk of electric
there is a risk of electric
shock! shock! shock! shock!
Figure 2 Figure 2 Figure 2 Figure 2