CHD Elektroservis VS-MIDI 8-434, Руководство по установке

Страница: 13 / 16

Vermona Synthesizer MIDI Interface Vermona Synthesizer MIDI Interface Vermona Synthesizer MIDI Interface Vermona Synthesizer MIDI Interface
VS VS VS VS----MIDI MIDI MIDI MIDI Installation Installation Installation Installation Manual Manual Manual Manual
8 88 8----434 / 434 / 434 / 434 / v. 2.00 v. 2.00 v. 2.00 v. 2.00
Copyright © 2022 CHD Elektroservis. All rights reserved.
No part of this publication may be reproduced in any form without the written permission of CHD Elektroservis.
13
13 13
13
Fig. 2.5.3 Fig. 2.5.3 Fig. 2.5.3 Fig. 2.5.3
c) Remove the protective foil form the self-adhesive
supports of the interface board (fig. 2.5.2).
d) Attach the interface board to the instrument’s cover
so that the side with two 2-pin connector headers and
7-pin connector header points to right as shown on the
figure 2.5.3. Than fix the self-adhesive supports by
pressing down to the panel.
2.5.2
2.5.2 2.5.2 2.5.2 CONNECTION OF CABLES CONNECTION OF CABLES CONNECTION OF CABLES CONNECTION OF CABLES
The newly installed interface bunched cables will be plugged to the interface board as shown on figures 2.5.4 to
2.5.6.
Fig. 2.5.4 Fig. 2.5.4 Fig. 2.5.4 Fig. 2.5.4
a) Plug two 2-pin connectors of the MIDI cables to X3 (“IN”) and X4 (“THRU / OUT”) plug heads. Orientation of
the connectors is given by the connector lock so they cannot be plugged reversely but be sure that the
connectors are not exchanged: MIDI input must be plugged to X3 head and MIDI output to X4 head (fig. 2.5.5).
b) Plug the 5-pin connector of the power supply cable to X2 plug head. Orientation of the connector is given by
the connector lock again (fig. 2.6.6).
c) Plug the 7-pin connector of the control signals cable to X1 plug head. Orientation of the connector is given by
the connector lock again (fig. 2.6.6).
Fig. 2.5.5
Fig. 2.5.5 Fig. 2.5.5
Fig. 2.5.5 Fig. 2.5.6
Fig. 2.5.6 Fig. 2.5.6
Fig. 2.5.6