Configuring through a web browser
51
There are three modes available:
a)
Auto Rover:
The receiver will serve as a rover after this mode is enabled, and
then receive correction data through the working mode set last time.
b)
Auto Base:
The receiver will serve as a base after this mode is enabled, and
then broadcast correction data based on coordinate inputted by user, or
obtained through autonomous positioning automatically.
c)
Manual Base:
The receiver will serve neither as a base or a rover after this
mode is enabled. Users need to configure the receiver manually.
For
Reference Latitude
and
Reference Longitude
:
There are mainly three methods to enter the reference coordinates and shown as
follows:
a)
Acquire Current Position
: Click this button to acquire current position
obtained through autonomous positioning automatically.
b)
Manual Input
: Manually input the coordinate of a control point.
c)
From CORS
: After the receiver logging in CORS, the software can record the
coordinate of current position based on fix solution.
For
Sample for Average
:
Users can determine the positioning limit and sampling amount. The positioning limit
falls into two types:
a)
Single Solution Coordinates
: Collect the coordinates of receiver obtained
through autonomous positioning.
b)
Fixed Solution Coordinates
: Only collect coordinates of receiver with a fixed
solution.
After the configuration of positioning limit and sampling amount, click
to
carry out sampling and averaging → the progress bar will show the progress → the
result will be served as the coordinate of current positon.
If users need to save the changes, please tap
button.
6.3.4 Receiver Reset submenu
Use this screen to completely or partially reset the receiver:
