iGage
X9x User Manual
page 23 of 53
…
14.
Click on the Receiver tab:
Enter the correct Antenna Height. If you have a
metric pole, you can enter ‘M’ after the number
and SurvCE will convert the measurement
automatically.
Check the antenna L1 offset carefully.
If you have a matched pair of receivers, you don’t
need to worry about it. But if you are connecting
to another base, you need to match the L1 offset
carefully. Pay attention to Relative vs. Absolute
antenna calibrations.
15.
Click on the RTK tab:
NOTE: You may choose CMR+ or RTCM3 for the
message type, however the Base and Rover MUST
Match Exactly!
Typically
X900+
=RTCM3.2
X91+
= CMR+
If you uncheck ‘Use Any Base ID’ then the entered
base ID must EXACTLY match the base.
16.
Select the Internal UHF device, click on the
‘hammer/wrench’ button to change the radio
frequency and over-the-air protocol:
Set the Protocol to Trimmark3.
Set the Channel to match the Base transmitter
channel:
The rover frequency must match the frequency
selected on the base. Noted that the rover