4. Operating Instructions
Operating Modes
x
A stand-alone mode will listen to sound and run through its range of built-in programs. An optional
CH-X wired controller provides remote blackout control.
x
Master/Slave mode will allow the use of up to 32 units in a synchronized light show.
x
DMX control mode will provide the greatest flexibility and creativity. Each fixture trait can be controlled
individually using any universal DMX-512 controller.
Stand Alone
The Stand Alone mode is activated automatically when no DMX signal is sensed, or a controller is not
connected. The Stepper will run through its built in programs as it listens to the sound. The optional CH-X wired
controller also provides a blackout function.
Master/Slave
The Master/Slave mode will allow you to link up to 32 units in a daisy chain fashion. In this mode, the first unit in
the daisy chain will automatically command all other units following. An optional CH-X controller connected to
the first unit in the chain will allow a blackout function for the entire chain. Connecting the Stepper™ for
(Master/Slave) operation does not require any menu or setting selections. Simply connect each unit in a daisy
like fashion using qualified 3-pin DMX cables as described below.
M A S T E R / S L A V E S E T T I N G S
1)
Connect the male 3-pin connector side of the DMX cable to the output (female) 3-pin connector of the first
fixture.
2)
Connect the female end of the cable coming from the first fixture to the male input connector of the next
fixture. Then, proceed to connect from the output as stated above to the input of the following fixture as
illustrated below. Repeat this process until all lights are connected.
Note!
For additional information on linking fixtures read under section “DMX Primer”
DMX Mode
Operating in DMX Control mode gives the user the greatest flexibility when it comes to customizing or creating
a show. You can tailor your programming to suit a specific event. Whether it is a wedding where a spot light
may be required, or a lead singer requiring a color solo, the opportunities are endless. In this mode you will be
able to control each individual trait of the fixture independently
Note!
Enable DMX control on the Stepper™ by setting dipswitch 1-9 with the desired starting address.
Stepper User Manual
8
2006-12-12/09:53
