Chauvet Rogue r2 Beam, Руководство пользователя

Страница: 10 / 33

Setup
-6- Rogue™ R2 Beam User Manual Rev. 2
3. S
ETUP
AC Power
Each Rogue™ R2 Beam has an auto-ranging power supply that works with an input voltage
range of 100 to 240 VAC, 50/60 Hz. To determine the power requirements for each Rogue™ R2
Beam, refer to the label affixed to the product. You can also refer to the
Technical Specifications
chart in this manual.
The listed current rating indicates the maximum current draw during normal operation. For more
information, you may download Sizing Circuit Breakers from the CHAUVET® website:
www.chauvetlighting.com/download/pro .
Always connect this product to a protected circuit with an appropriate electrical ground
to avoid the risk of electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
AC Plug
The Rogue™ R2 Beam comes with a power input cord terminated with a Neutrik® powerCON®
A connector on one end and an Edison plug on the other end (U.S. market). If the power input
cord that came with your product has no plug, or if you need to change the Edison plug, use the
table below to wire the new plug.
Connection Wire (U.S.) Wire (Europe) Screw Color
AC Live Black Brown Yellow or Brass
AC Neutral White Blue Silver
AC Ground Green/Yellow Green/Yellow Green
Fuse
Replacement
1. Disconnect this product from the power outlet.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove the blown fuse and replace with a another fuse of the same type and rating
(F 7 A, 250 V).
4. Screw the fuse holder cap back in place and reconnect power.
Make sure to disconnect the product’s power cord before replacing a blown fuse. Always
replace the blown fuse with another of the same type and rating.
DMX Linking
You can link the Rogue™ R2 Beam to a DMX controller using a 3- or 5-pin DMX connection. If
using other DMX-compatible products with the Rogue™ R2 Beam, you can control each
individually with a single DMX controller.
DMX
Personalities
The Rogue™ R2 Beam uses a 3- or 5-pin DMX data connection for the 15- and 18-channel
DMX personalities.
•
Refer to the Introduction chapter for a brief description of each DMX personality.
•
Refer to the Operation chapter to learn how to configure the Rogue™ R2 Beam to work in
these personalities.
•
The DMX Values section provides you with detailed information regarding the DMX
personalities.
If you are not familiar with or need more information about DMX standards, Master/Slave
connectivity, or the DMX cables needed to link this product to a DMX controller,
download the DMX Primer from the CHAUVET® website:
www.chauvetlighting.com/download/pro .