![Chauvet Legend 330SR Spot Скачать руководство пользователя страница 3](http://html.mh-extra.com/html/chauvet/legend-330sr-spot/legend-330sr-spot_quick-reference-manual_2593097003.webp)
Legend™ 330SR Spot QRG
EN
3
Contact
Outside the U.S., United Kingdom, Ireland, Mexico, or Benelux, contact your
distributor to request support or return a product. Visit
www.chauvetprofessional.com
for contact information.
What is
Included
•
Legend™ 330SR Spot
•
Neutrik® powerCON® power
cord
•
2 Omega Brackets
•
Warranty Card
•
Quick Reference Guide
AC Power
This product has an auto-ranging power supply that can work with an input
voltage range of 100–240 VAC, 50/60 Hz.
To eliminate wear and improve its lifespan, during periods of non-use
completely disconnect from power via breaker or by unplugging it.
AC Plug
Connection
Wire (U.S.)
Wire (Europe)
Screw Color
AC Live
Black
Brown
Yellow/Brass
AC Neutral
White
Blue
Silver
AC Ground
Green/Yellow
Green/Yellow
Green
Replacing the
Fuse
1.
Disconnect this product from power.
2.
Using a Phillips #2 head screwdriver, unscrew the fuse holder cap
from the housing.
3.
Remove blown fuse and replace with a good fuse of the same type and
rating.
4.
Screw the fuse holder cap back in place and reconnect power.
DMX Linking
The Legend™ 330SR Spot will work with a DMX controller using a regular
DMX serial connection. A DMX Primer is available from
www.chauvetprofessional.com
.
DMX Connection
The Legend™ 330SR Spot uses a regular DMX data connection for its DMX
personalities:
Mode1 (21)
and
Mode2 (27)
. See the User Manual to connect
and configure for DMX operation.
Lamp
Replacement
1.
Turn the fixture off and disconnect it from power.
2.
Wait at least 15 minutes for the lamp to cool down.
3.
Remove back cover using the 2 Phillips-head ¼-turn screws.
4.
Take note as to the orientation of the lamp. Vent holes on the front of
the lamp should align horizontally with the air vents on the lamp
frame. Orient the rear of the product so that the fan is facing
downward.
5.
Using the lamp base, push the lamp down against the spring clips
located on the bottom, and then roll the lamp out the top.
6.
Remove the 2 wires connected to the lamp by the spade connectors.
7.
Reverse steps 3 thru 6 above to install the new lamp.
Please refer to the User Manual for more detailed instructions with
images.