Chauvet JAM Pack Emerald, Руководство пользователя

Страница: 7 / 15

JAM™ Pack Emerald User Manual Rev. 1 Page 7 of 15
3. S
ETUP
Fog Machine
AC Power
The JAM™ Pack Emerald fog machine has a fixed voltage power supply and it can work
with an input voltage of 120 VAC at 60 Hz or 230 VAC at 50 Hz. The listed current rating
indicates the product’s average current draw under normal conditions.
•
Always connect the product to a protected circuit (circuit breaker or fuse).
Make sure the product has an appropriate electrical ground to avoid the risk
of electrocution or fire.
•
To eliminate wear and improve its lifespan, during periods of non-use
completely disconnect from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
Fog Machine
Fuse
Replacement
1. Disconnect the fogger from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and replace with a
fuse of the exact same type and rating.
5. Re-insert the fuse holder and reconnect power.
The product does not ship with a spare fuse; however, the safety cap has room for a
spare.
Always replace a blown fuse with a fuse of the same type and rating.
External AC
Power Supply
The JAM™ Pack Emerald UV Strobe Combo has an external auto-ranging power supply
that can work with an input voltage range of 100 to 240 VAC, 50/60 Hz.
To determine the product’s power requirements (circuit breaker, power outlet, and wiring),
use the current value listed on the label affixed to the power supply’s back panel, or refer
to the product’s specifications chart. The listed current rating indicates the product’s
average current draw under normal conditions.
•
Always connect the product to a protected circuit (circuit breaker or fuse).
•
To eliminate wear and improve its lifespan, during periods of non-use
completely disconnect from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0 to 100% switch.