4. Operating Instructions
10
10/9/2009 2:29 PM
Mounting
bracket
Bolt
locations
Safety cable
attachment point
Hanging clamp
attachment point
Be sure to loop the safety cable
through the 2 loops, as shown
in the illustration above.
The safety cable must be
capable of support up to 10
times the weight of the fixture.
Mounting
Orientation
The
Intimidator™ Spot XYZ
may be mounted in any safe position provided there is
adequate room for ventilation.
Rigging
Be sure that the structure can support 10 times the weight of the fixture. Please see the
“Technical Specifications” section of this manual for a detailed weight listing. Mount the
fixture securely. Two hanging clamps for truss mounting may be used, or nuts and bolts for
permanent installation may be used. The holes in each bracket are 13 mm in size. When
rigging, consider routine maintenance and control panel access. Please see the following
steps for installation.
If the power link out is intended to be used with multiple fixture, take into account the
length of each power cable, and mount the fixtures close enough to one another to
accommodate for this.
Attach both included bolts in the locations indicated below, using a metric 8 mm Allen
wrench.
Attached 2 hanging clamps to the bracket in each of the two locations indicated below
Safety cables must always be used.
Do NOT mount this fixture sideways!
