Chauvet Green Thinking Professional Vesuvio RGBA, Руководство пользователя

Страница: 14 / 17

Operation
-10- Vesuvio™ RGBA User Manual Rev. 1
Starting Address
The Vesuvio™ RGBA uses 9 DMX channels in its DMX mode, which defines the highest
configurable address to
504 . If unfamiliar with DMX, download the DMX Primer from
www.chauvetlighting.com/download/pro .
To select the starting address, do the following:
1. Press <
FUNCTION > repeatedly until DMX512 Add. shows on the display.
2. Use < UP > or < DOWN > to select the starting address 1–512 .
Make sure that the starting addresses on the various products do not overlap due
to the address setting.
Setting the LED Color To adjust the color of the LED’s, do the following:
1. Press <
FUNCTION > repeatedly until Color shows on the display.
2. Use < UP > or < DOWN > to select the desired color ( 1–7 ).
Timer Mode When in Timer mode, the Vesuvio™ RGBA will produce haze and light in pre-configured
time intervals defined by the
Interval Set and Duration Set menu options. See the
Timer Mode Parameters section for details about how to configure these parameters.
To operate in Timer mode, do the following:
1. Press <
TIMER > and the display will show a countdown of the interval timer.
2. When the counter reaches zero ( 0 ), the Vesuvio™ RGBA will start producing haze
and light.
3. The haze and light output duration during Timer mode is set by the Duration Set
menu option.
4. The color of the LEDs is set using the Color menu option.
5. This cycle will repeat itself until you press < TIMER > again or until the Vesuvio™
RGBA runs out of fluid.
Manual Mode In the Manual mode, the Vesuvio™ RGBA will output haze and light for as long as
<
MANUAL > remains pressed. The output volume will be at 100% full haze and light
output.
To operate in Manual mode, do the following:
•
Press < MANUAL >.
This mode will continue until you release < MANUAL > or until the Vesuvio™ RGBA runs
out of fluid.
Timer Mode
Parameters
These parameters determine the intervals for the Vesuvio™ RGBA while in Timer mode.
To configure these parameters do the following.
1. Press <
FUNCTION > repeatedly until Interval Set shows on the display.
2. Use < UP > or < DOWN > to select the time in seconds ( 1–200s ) between haze and
light output.
3. Press < FUNCTION > repeatedly until Duration Set shows on the display.
4. Use < UP > or < DOWN > to select the time in seconds ( 1–10s ) for the duration of the
haze and light output.