Chauvet GEYSER P4, Руководство пользователя, Страница: 16 / 19

Page 16 of 19 Geyser P4. User Manual Rev. 2
General Troubleshooting
Symptom Display Possible Cause Possible Action
No output or
low output or
fog machine is
spitting fluid
“ Addr ” or “ HEAT ”
Wrong fluid
Clean thoroughly with CHAUVET® FCQ. For
full instructions, see
Fogger Maintenance . Refill
with CHAUVET® water-based fog fluid.
Blocked pipes or
failing part
Contact Customer Service
Circuit breaker or fuse
keeps blowing
Off
Excessive load on the
circuit Make sure that the total load does not exceed
80% of the breaker or fuse nominal current
Short circuit along the
power lines Check the power lines and power cords
Product does not
power up
Off
No energy on power
outlet Check power outlet
Change to another outlet
Loose or damaged
power cord Check the power cord
Blown fuse Replace blown fuse with a good one of the
same type and rating
Internal problem Send product for repair
Product does not
output fog
“ Addr ” or “ HEAT ”
No fluid Turn the product off and replenish the fog fluid
(use only CHAUVET® water-based fog fluid)
Heater or pump
clogged Clean thoroughly with CHAUVET® FCQ. For
full instructions, see
Fogger Maintenance . Refill
with CHAUVET® water-based fog fluid.
Wired remote
disconnected or
defective Make sure that the remote is connected
Try the remote on another Geyser P4 if
available
Inappropriate wired
remote operation See Wireless Remote Control for instructions
Wireless remote
receiver not
connected Make sure that the wireless remote receiver is
connected
Wireless remote
transmitter ran out of
battery Replace battery on wireless remote transmitter
Internal problem Send the product for repair
If you still experience problems after trying the above solutions, contact Chauvet
Technical Support.