Eclipse™ RGB User Manual
11
Rev.10 ML
3.
S
ETUP
AC Power
This product has an auto-ranging power supply that can accommodate a wide range of input
voltages. The only thing necessary to do before powering on the unit is to make sure the line
voltage you are applying is within the range of accepted voltages. This product will
accommodate between 100~240V AC 50/60 Hz. All products must be powered directly off a
switched circuit and cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel is used solely for a 0 to 100% switch.
Mounting
Orientation
This product may be mounted in any safe position, provided there is adequate room
for ventilation.
Rigging
It is important never to obstruct the fan or vents pathway. Mount the product using, a
suitable “C” or “O” type clamp. Adjust the angle of the product by loosening both
knobs and tilting the product. After finding the desired position, retighten both knobs.
When selecting installation location, take into consideration access and routine
maintenance.
Safety cables must always be used.
Never mount in places where the product will be exposed to rain, high humidity,
extreme temperature changes or restricted ventilation.
Proper Use
This product is for overhead mounting only. For safety purposes, CHAUVET®
recommends mounting your lighting effect products on steady elevated platforms or
sturdy overhead supports using suitable hanging clamps. In all cases, you must use
safety cables. You can obtain appropriate mounting hardware from your lighting
vendor.
International laser safety regulations require that laser products must be operated in
the fashion illustrated below, with a minimum of 3 meters (9.8 ft) of vertical separation
between the floor and the lowest laser light vertically. Additionally, 3 meters of
horizontal separation is required between laser light and audience or other public
spaces.
CAUTION - USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE