Menu Functions
M
ENU
O
PTION
D
ESCRIPTION
DMX:
The fixture will be controlled by a DMX signal coming from a DMX controller.
The starting address must be selected, and can be set using the up and down
buttons.
Slave Unit:
Sets the fixture to run in sync with the Master. You must set the first
fixture in the data link to “Master” otherwise nothing will happen.
Sound Active – Master Unit:
Sets the fixture to Master status for Master-Slave
operation and the built in programs will be triggered by the sound. No data link is
required; all fixtures can be set to this mode for Stand-alone operation.
Automatic – Master Unit:
Sets the fixture to Master status for Master-Slave
operation and the built in programs will be triggered automatically to a pre-
programmed time interval. No data link is required; all fixtures can be set to this mode
for Stand-alone operation.
Blackout – Master Unit:
Sets the fixture to Master status for Master-Slave operation
and closes the shutter. No data link is required; all fixtures can be set to this mode for
blackout operation.
13 Channel Mode:
Sets the fixture to operate in 13 channel mode.
19 Channel Mode:
Sets the fixture to operate in 19 channel mode.
Operation
Stand-Alone Mode (Sound-Active, Auto Mode):
This mode allows a single unit to run to the beat of the music, or the unit will auto change in Auto
Mode.
1) Press
<MODE/ESC>
until
,
, or
is displayed.
2) Use
the
<UP>
and
<DOWN>
buttons to scroll through until the desired mode is displayed.
is auto mode;
is sound-active.
3)
The unit will react to the low frequencies of music via the internal microphone in Sound-Active
mode, or the unit will auto change in Auto Mode.
Master/Slave Mode (Master Sound, Master Auto):
This mode will allow you to link up to 32 units together without a controller.
1)
Use standard DMX cables to daisy chain your units together via the DMX connector on the rear
of the units. For longer cable runs we suggest a terminator at the last fixture. For more
information about terminators, see page 9.
2)
Choose a unit to function as the master. Press
<MODE>
until
,
, or
is displayed on the master unit.
3) Use
the
<UP>
and
<DOWN>
buttons to scroll through until the desired mode is displayed.
is auto mode;
is sound-active.
4) Press
<MODE>
until,
is displayed on the slave units.
Constellation User Manual
12
2007-01-09/10:53
