Setup
COLORado™ 3p Tour User Manual Rev. 02c
-8-
February 16, 2010
Mounting
Before mounting this fixture, read and apply the safety recommendations indicated in
the
Safety Notes
of this manual.
Orientation
Always mount this fixture in any safe position while making sure that there is adequate
room around it for ventilation.
Make sure to mount this fixture away from any flammable material as indicated in the
Safety Notes
.
Rigging
The COLORado™ 3p Tour consists of a sealed single module that comes with a
mounting bracket, which provides for individual floor or overhead mounting. The
COLORado™ 3 housing also has linking knobs and slots on its sides. This allows you to
stack several units vertically and horizontally to create panels or strips. Stack them
forming panels to increase the intensity of the projection for more distant throws or to
use as a blinder effect. Stack them forming strips to create runway lighting and
cycloramas.
CHAUVET® recommends following the general guidelines below when mounting the
COLORado™ 3p Tour.
•
When selecting an installation location, consider ease of access to the fixture for
operation, programming adjustments and routine maintenance.
•
Never mount the fixture in places where rain, high humidity, extreme temperature
changes or restricted ventilation may affect it.
•
Make sure that the location where you are mounting the fixture can support its
weight. Please see the
Technical Specifications
section of this manual for the weight
requirement of this fixture.
Stand-alone Procedure
This fixture includes a mounting yoke to which you can attach one or two rigging clamps.
You must supply your own “C” or “O” clamps and make sure that they are capable of
supporting the weight of this fixture. CHAUVET® recommends using at least two
mounting points per fixture when hanging this fixture.
Stand-alone
Mounting
Diagram
Clamp (not Included)
Safety Cable
(Included)
Overhead Mounting
Floor Mounting
