COLORado™ 2 User Manual
12
2/18/2009 12:45 PM
Lens Assembly Installation/Replacement
The COLORado
™ 2 comes with 15 lens assembly pre-installed from the factory. However, there is 1 other optional
lens kit available
(CL20X30)
, which is the 30 degree. This is available as an accessorie, and will alter the beam
angle. Please follow the below instructions for proper replacement/installation.
1.
Remove the gel frame holder by removing the 4 thumbscrews.
2.
Remove the front cover (black) by removing the 8 Phillips #2 screws that hold it in place. Use
caution, because the glass is not secured under this cover and may fall loose.
3.
Now, remove the glass cover.
4.
After removing the glass cover, remove the screws that hold the lens assembly in place. There
are 6 Phillips #2 screws that secure this assembly in position.
Note: use care when performing this procedure, as this gives you direct access to
the LEDs, which are very fragile.
5.
You now should have full access to the lens assembly. This must be removed and the old lenses
must be replaced with the new lenses. The same assembly is to be reinstalled with the new
lenses in place and the process is complete.
Warning!
1. When replacing the lens assembly, please make sure that the power is
disconnected from the fixture beforehand.
2. You must also be VERY CAREFUL when opening this fixture. Improper handling
on the behalf of the user may void the IP-66 rating of this fixture.
4. Lens assembly
Watertight seal
3. Glass cover
2. Front cover