Chassis Plans CCIR-17, Техническое описание

Страница: 55 / 62

Chassis Plans CCIR -17 Technical Reference Appendix A – Display Serial Control Programming
Page 53
Table 21 - Parameter Setting - Immediate, Relative, Reset and Query
# - Function in ARGB mode only
Function Command Description Acknowledge (if enabled)
Select RS-232
acknowledge 0xc1, “0” | “1” Disable/enable command
acknowledge. “0” – acknowledge disabled.
“1” – acknowledge enabled.
Auto-setup
#
0xc3 Start auto-setup of current
mode. “0” – fail.
“1” – successful.
Command
availability 0xc4, n Check whether a command is
available. “0” – not available.
“1” – available.
Auto-calibration
#
0xc5 Start auto-calibration of gain of
the RGB amplifier. “0” – fail.
“1” – successful.
Query BIOS
version 0xcb, “0” Read BIOS version “nnnn” = BIOS ver. “nn.nn”
Query PCBA
number 0xcb, “1” Read PCBA number “nnnn” = PCBA number
ALR-1400=”41710”
Load factory
defaults 0xce Reset all parameters to factory
default value “1” – successful.
Table 22 - Other Control
e.g “1””0”
 0xe0 0x31 0x30
* This control can only
function when JP2 sets 3-4
closed
* Apply for inverter control
voltage in range of 0~5V.
Each step interval is in 1
Backlight on/off
control 0xe1,
“0” |
“1” |
“r” | “R” |
“?”
Set backlight brightness =
Disable backlight
Enable backlight
Reset
Query
Backlight working status Backlight on/off.
“1” = normal (Default)
OSD menu Lock
(Functon
available in
V1.80.00 or later
revision) 0xf6,
n | “0” | “1” |
“r” | “R” |
“?” OSD menu Lock Off/ On
Reset
Query “0” – OSD Lock Off
“1” – OSD Lock On