DuraShield Installation Manual
Motorized – Inside Standoff
Chase Doors Inc.
800-543-4455
3/12
DuraShield Installation Manual RB0375
Page
5
3.
Roll Installation - NOTE: If you have a Roll Cover with Roll Cover Brackets
provided see section 10 for installation before installing the Roll
Lift the roll into position. On the drive side, locate the pillow block onto the T Bracket
and install the Bearing block to T bracket bolts. On the non drive side, either locate the
pillow block to the T Bracket and install the T Bracket bolts or, for rolls supplied with a
balancing spring, slide the Shaft Retainer Bracket onto the shaft and install the T
Bracket bolts. Align the shaft keyway as shown with the locking allen screw and
tighten the locking screw securely.
Be sure the curtain is coming off the back of the roll.
Standard Pillow Block Bearing Shaft Retainer Bracket used with Balancing Spring
Adjust the roll to wall dimension for both T Brackets as shown below and tighten the Bearing
and Retainer bolts.
1 5/8"
REAR OF CURTAIN ROLL TO
WALL MINIMUM DIMENSION
