Charnwood W570, Руководство пользователя

Страница: 10 / 20

Rollers are built into the top of the thicknesser to
facilitate the passing of workpieces from the back
to the front of the machine when multiple cuts are
required.
Timber placed on top of the machine can be
easily moved by the operator ready for the next
cut.
Fine Tuning
Adjusting The Thickness Scale
The finished dimension scale may need to finely
adjusted before being used.
To adjust the scale:
Plane both sides of a sample board and
accurately measure its thickness.
Compare the measured thickness with the
reading on the Thickness Scale.
If the reading on the scale is incorrect, loosen the
screw which holds the plastic pointer and adjust
accordingly.
Adjusting Bolt Locking Nut
Adjusting The Extension Tables & Rollers
The Table Extensions are mounted at the front
and rear of the main table and must be accurately
adjust to ensure correct operation. If they need
adjustment;
Raise the cutter head to give clear access to the
tables.
Place a straight edge across the main table and
the extension table. The straight edge should be
in close contact with the full length of the main
table and the roller on the end of the extension
table.
If adjustment is required, loosen the locking nut
then turn the adjusting bolt, on each side of the
table, until the extension table is level.