Charnwood Cove 2B, Руководство по эксплуатации и установке

Страница: 5 / 18

has two positions:-
1) In the solid fuel position the grate bars are vertical with gaps in
between allowing the primary combustion air to come up through
the grate and through the fuel bed.
2) In the wood position the grate bars are horizontal, allowing the
combustion air to come round the sides of the grate and over the top
of it. When in the wood position ash is able to build up on the grate
as is necessary for effective wood or peat burning.
Movement of the grate from one position to the other is effected
using the tool supplied as shown in Fig.2. The grate is put into the
solid fuel position by moving the tool up until the handle is in the 1
o'clock position. The grate is put into the wood position by moving
the tool down until the handle is in the 5 o'clock position. To riddle
the appliance when burning solid fuels the tool should be moved
between the 1 o'clock and 3 o'clock positions several times. When
burning wood or peat the ash should be allowed to build up and
riddling should only be carried out once or twice a week.
LIGHTING
The stove may be lit using dry kindling wood and paper or fire
lighters. Set the grate into either the closed position or the open
position as required. Place the paper, or fire lighters, and kindling on
the grate and cover with a few small dry logs. Open the air controls
fully (see Fig. 1.) Light the paper or fire lighters. Close the door until
the fuel is well ignited then load with fuel. Once the fire is up to
temperature the airwash system will begin to work, so allow the fire
to become hot before adjusting the air controls to the required
setting.
On initial lighting, the stove may smoke and give off an odour as the
silicon paint with which the firebox is painted reacts to the heat. This
is normal and will cease after a short time, but meanwhile the room
should be kept well ventilated.
At first only light a small fire and burn it slowly for two hours to allow
any residual moisture in the bricks to evaporate.
When relighting the stove, riddle slightly, and then empty the ashpan.
When burning wood, ash should be allowed to build up and only
riddled when the ash begins to cover the slots in the rear fireplate.
The fire should be riddled with the door shut (see Fig. 2.) Place the
tool onto the riddling lever and rotate between the 1 o'clock and 3
o'clock positions several times. Too much riddling can result in
emptying unburnt fuel into the ashpan and should therefore be
avoided. After riddling, the grate should be put back into the
position as required (the tool should be in the 1 o'clock position for
open grate or in the 5 o'clock position for closed grate).
Keep the firebox well filled but do not overfill to prevent fuel from
spilling over the top of the front fire bar. Logs should be evenly
distributed filling across the fire bed to give the most pleasing flame
pattern
Care should be taken especially when burning wood that fuel does
not project over the front fire bar or damage to the glass may be
caused when the door is closed. It can also cause the glass to black
up.
CONTROLLING THE FIRE
RIDDLING
REFUELLING
ASH CLEARANCE
The rate of burning and hence the output is regulated by the control
knob on the side of the fire and the airwash control (see Fig.1).
The control knob is linked to a thermostat which senses the boiler
temperature. The number at the front of the knob is the number at
which it is set.
The airwash control should be kept at least slightly open most of the
time to keep the glass clean. It may be fully opened when rapid
heating is required or to help clean any deposits from the glass. It will
not be possible to keep the glass clean if this control is fully closed,
particularly immediately after refuelling.
The ashpan should be emptied regularly before it becomes too full.
Turn the knob clockwise to increase the water
temperature or anti-clockwise to decrease.
Maximum filling height is such that logs cannot fall from the fire
when the doors are opened. Liquid fuels are not to be used on this
stove.
Fig. 2. Multifuel Grate
Solid F
uel P
osition
W
ood P
osition
Riddle
Door Opening Tool rotated 180°
and pushed fully on to Riddler Knob
®
charnwood
OPERATING INSTRUCTIONS
5