8
LT2505 (ISS 13)
SECTION FOUR Cleaning and Replacing Fuel Bed (user instructions)
Important: - Refer to the Health & Safety Notice located on page 5 of this booklet before cleaning or
replacing any refractory material.
Note: Soot deposits on the fuel bed, may be burnt off by operating the fire for approximately 1 hour on high.
The fuel bed components are delicate and they should be handled with great care.
The loose parts and moulded shapes may be removed for cleaning. They can be brushed very gently with a soft
brush to remove dust or any deposits.
A vacuum cleaner may only be used after the loose components and moulded shapes have been removed.
Note
Dye is available for touching up coal surfaces where the black colouring may have rubbed off in use.
FUEL BED LAYOUT (COAL OPTION)
•
Ensure the BASE MATRIX is in position as shown centrally
located against the rear edge of the burner outlet.
•
Ensure the LEFT SIDE MATRIX is located into the space
between the BASE MATRIX and the left-hand side of the
fire back with the marking "LH" go against the left-hand
inside face of the fire back.
•
Ensure the RIGHT SIDE MATRIX is located into the space
between the BASE MATRIX and the right-hand side of the
fire back with the marking "RH" go against the right-hand
inside face of the fire back.
•
Locate 3 off of COAL "A" behind the BASE MATRIX
A
A
A
LEFT SIDE
MATRIX
RIGHT
SIDE
MATRIX BASE
