4
GO ECO Range
Issue 01.1 05/17
3.0 Preparation of Stove for Installation
.
Your stove comes fully assembled, checked and packed in a protective plywood crate.
Carefully remove the straps and lift off the top and upper crate. Remove any plastic
packaging, open the door and remove all the contents. See List of Components section
(above) and check contents carefully.
3.1.
If required remove the stove door if required for easier handling of the unit – this is not
normally required. Remove the retaining circlips on the bottom of the hinge pins. Open
to about 30 degrees and lift upwards to disengage the hinge pins.
3.2.
Remove all the interior components of the stove using the following procedure. SEE
ALSO MAINTENANCE GUIDE section.
3.2.1.
Remove the baffle plate by supporting the plate with both hands and lifting the
front edge towards you and sliding the back edge off the back support. Slots in the
baffle should allow it to be lowered off the front baffle pins and into the firebox.
There is a ceramic insulating board on top of the baffle plate – place this carefully
to one side to avoid breakage. The plate can then be removed from the firebox.
3.2.2.
Next remove the fuel retainer bars by lifting upwards until they can be
disengaged from the side firebox liners and rotated slightly to bring out of the front
of the firebox.
3.2.3.
Remove the two cast ceramic firebox side liners by gently pulling the front edges
forward and sliding away from the 45 degree mitre joint with the back liner at the
rear corners. Take great care not to chip or damage the surfaces of these ceramic
components – support the rear liner so that it cannot fall over and break!
3.2.4.
Now remove the firebox rear liner. Handle and store these ceramic liners very
carefully to one side where they will not get broken.
3.3.
The flue spigot collar may now be configured for vertical or horizontal connection as
required.
3.3.1.
Locate the 3 x M6 cap screws, 3 x nuts and the spigot which are packed in the
firebox or ash pan section.
3.3.2.
Fit the spigot to the top outlet or rear outlet using the gasket provided or fire
cement to seal.
3.3.3.
If required the blanking plate can now be used to cover the hole in the top plate
or rear plate. Use the screws as studs and use the nuts on the threads to clamp the
plate tightly against the gasket or use fire cement to seal.
3.4.
Lift the stove into its final position using an assistant to help.
3.5.
Make the connection to the flue, chimney or liner using appropriate rigid flue pipe or
adaptor, making sure to seal all joints carefully.
3.6.
Now proceed to complete the installation of the stove according to these instructions,
Building Regulations and current installation standards or HETAS competent person
scheme advice.
3.7.
The internal parts of the stove can be re-assembled as the reverse of the previous
removal instructions.
