Multifunction Infrared Remote Handset.
To Reset the Heater
Your heater includes a protection system that shuts off the heater if it overheats for any
reason:
1) Turn unit to off.
2) Unplug unit wait 5 minutes.
3) Plug in and turn on.
●
Operating by Remote Handset
In order to protect the product from becoming too hot, there is a 10s delay when
turning on the heater; also there is a 10s delay when turning off the heater fan.
Make sure the batteries are installed properly in the remote control.
The effective range of the remote control is up to 4 meters or 13 feet.
MAINTENANCE
Warning:
Before any maintenance and/or cleaning the exterior of the
fireplace, disconnect the unit from the power supply and leave until cooled
off.
Remote Handset Battery Replacement
Replace with two AAA batteries. Make sure the batteries are installed correctly in the
remote control.
Maintenance of Motors
The motors used on the fan and flame effect are pre-lubricated for extended bearing life
and require no further lubrication. However, periodic cleaning/vacuuming of the
fan/heater unit is recommended.
ICON
TITLE
FUNCTION
POWER Press once turns appliance and flame effects on. Press again
turns appliance and flame effects off.
FLAME
The fire has four flame effects, by pressing the flame effect
button the unit will cycle through each effect.
HEATER
Press once turns Low heat on. (Pilot lights illuminated
●○
)
Press again turns High heat on (Pilot lights illuminated
●●
)
Press third time turns heater off. (Pilot lights illuminated
○○
)
TEMP
Digital display shows the TEMP setting 23°C (default), with 14
settings circle from
“
OFF
”
,
“
16°C
”
to
”
28°C
”
.
The TEMP will increase by 1°C up to 28°C when pressed each
time.
By pressing the TEMP for 3S, the digital display can show
between °C and °F.
TIMER
Cycles from OFF, 0.5H, 1H, 2H, 3H, 4H, 5H, 6H, 7H, 8H, to 9H.
