13
Advance Mode
6b.30 Under the daily and week timer mode, Press
:
6b.31 To turn the heater off when the heater is on during a preset heating period.
6b.32 To turn the heater on when the heater is off in between preset heating periods.
Adaptive Start Control
6b.33 According to room temperature and set temperature, the heater will automatically come on in time to heat the room
to the set temperature at the set time. For example, if your timer is set to start at 18:00 and temperature is set to 23°C, the
fire will come on at 17:30 to ensure the room is 23°C at 18:00.
Window Open Detection
6b.34 When the transmitter detects a rapid drop in room temperature, it will be judged as a
window open, then the warning icon will be displayed and the heating will be turned off
automatically.
6b.35 After the indoor temperature has risen or a manual override of warning (by operating
remote control) has been done, the fire will return to normal working state.
Set up the communication between the remote and appliance
6b.36 The below operations should be carried out before programming, when changing to a new remote or in the event the
appliance cannot be controlled by the remote:
•
Hold the reset button for 3 seconds (pen point may needed) until you hear 3 short beeps from the unit, release the
button.
•
Press the
button on the remote, the programming is finished when you hear 1 long beep from the appliance.
6b.37 Resetting the code for remote control is necessary if the appliance operates wrongly under the external interference
signal or the remote control does not operate correctly.
•
Open the back cover of the remote control.
•
Press the Reset button.
•
Follow the steps 6b.36
Resetting the Thermal Cut Out
6b.38 The appliance is fitted with an Electronic Safety Control (E.S.). This is a safety device, which switches off the fire if, for
any reason, the appliance overheats, e.g. when covered. If the heater stops operating while the flame effect continues
working normally, this indicates that the E.S. Control is in operation. The E.S. Control can only be re-set after the appliance has
cooled down, and the appliance has been reset. Re-setting of the E.S. Control proceeds is as follows:
6b.39 Switch off the appliance (Manual On/Off switch) and leave it off for approximately 10-15 minutes.
6b.40 Remove any obstruction to the fan heater outlet or fan blades etc. Make sure that the power supply is disconnected
with the plug socket outlet while doing this.
6b.41 Switch on the appliance and the E.S. Control will be re-set.
6b.42 Ensure that the appliance is functioning correctly. If the E.S. Control operates again, the appliance should be checked by
a competent electrician.
10.
MAINTENANCE
WARNING:
Before any maintenance or cleaning of the exterior of the fireplace, the unit should be disconnected from the
power supply until it is cool off.
Remote Handset Battery Replacement
7.1 When the batteries are at full power, the battery symbol will show
