PPE-5011.E
September 2013 Page 1 of 5
Tester, Combination, 3-State
Operation, Installation and Maintenance
Pass Range 750K - 35M
Figure 1. Charleswater
Combo Tester
Description
The Charleswater Combo Tester is a 3-state touch tester
designed for fast, frequent testing of ESD personnel
grounding devices. The Combo Tester incorporates a
unique dual test circuit design which improves accuracy of
testing and eliminates the need for separate wrist strap and
foot grounder test units. The
Kilohm - 35 Megohm circuit, ideal for testing of wrist straps
and footwear.
Test parameters are factory set but can be adjusted to
match your own specifications. The Combo Tester is
very simple to operate. A green light signals the user that
everything is OK. A red light and an audible indicator means
that the circuit resistance is either too low or too high.
The testers each include a
, which
converts the banana plug on the face of the
unit into a 10mm snap. NOTE: Once the
has been put into the plug socket, it
cannot be removed.
The tester operates on either a 9 volt battery or a special
AC adapter. The combo tester is available in two models:
the tester alone, or the tester with a stand. A footplate is
also available for use with the
.
TECHNICAL BULLETIN PPE-5011.E
© 2013 Charleswater
Unit 17. Millbrook Business Park, Sybron Way • Crowborough, East Sussex TN6 3JZ United Kingdom
Phone: 00 44 (0) 1892-665313 • Internet:
Model Description
Tester, Banana Jack
Tester with stand
Footplate, stainless steel
AC Adapter, 220V
CAUTION: Use only the AC adapter designed for this
unit. Using any other adapters may damage the unit
and void the warranty.
Inspection
Remove the tester from the carton and inspect for damage.
Items included with model
:
1 Combo Tester
1 9 volt battery
Items included only with model
1 Combo Tester
1 Base Plate
1 Pedestal tube with bracket and boot installed
1 10cm banan plug connector
1 Vinyl insulator cap
1 Wall poster
1 5/32" hex wrench
1 9 volt battery
Model number
is ideally suited for testing foot
grounding devices. Item number
can also be used in
conjunction with the combo tester for testing of footwear.
Installation of Model
The Combo Tester may be used as a portable unit, or may
be permanently mounted on either a table or a wall. Please
refer to the following instructions when installing your tester.
Stationary Installation
If you will be using the tester as a portable unit, you may
prefer to mount the unit to a table or wall. Three keyhole
slots on the back of the unit are included to allow you to
attach the tester to a stationary surface.
Figure 2. Mounting hole locations
1. Select location for mounting tester. Install three #6 or #8
screws spaced as illustrated in figure 3, into a wall or other
vertical surface. Make sure that the screw heads do not
project out more than 6.35 mm from mounting surface. The
template on page four is actual size.
2. Mount the tester on the screws, pulling down to lock it in
place.
Made in the
United States of America
