Original Instruction
PR482/SK5PR
Attachment Operator’s Manual
Publication number: ID0443833; page 3 of 6
Connect Attachment
Attachment
1. Position attachment on
level surface with enough
space behind it to
accommodate machine.
2. Start engine.
3. Tilt mount plate (2)
forward.
4. Position mount plate in
the upper lip of the
receiver plate (1) on
attachment.
5. Raise lift arms while tilting back mount plate.
6. Pins will automatically
engage.
7. Ensure lock pins are
engaged by rotating
attachment down. Verify
that bottoms of lock pins
are visible under
attachment plate.
Hydraulic Hoses
1. Remove dirt and debris
from hydraulic couplers.
2. Connect male coupler on
attachment to female
coupler (3) on machine.
3. Connect female coupler
on attachment to male
coupler (1) on machine.
4. Ensure that connections are secure by pulling on hoses.
IMPORTANT:
Before connecting attachment to machine,
ensure that mount and receiver plates are free of dirt and
debris and that latch handles are down.
IMPORTANT:
Attachment should be raised enough to clear
the ground. Mount plate should be tilted back fully.
t05om026c.eps
1
2
t43om007w.eps
Pressurized fluid or air
could pierce skin and cause injury or
death. Stay away.
To help avoid injury:
• Use a piece of cardboard or wood, rather than hands, to
search for leaks.
• Wear protective clothing, including gloves and eye
protection.
• Before disconnecting a hydraulic line, turn engine off
and operate all controls to relieve pressure.
• Lower, block, or support any raised component with a
hoist.
• Cover connection with heavy cloth and loosen
connector nut slightly to relieve residual pressure. Catch
all fluid in a container.
• Before using system, check that all connections are tight
and all lines are undamaged.
• If you are injured, seek immediate medical attention
from a doctor familiar with this type of injury.
Hot parts may cause burns.
Do not touch until cool or wear gloves.
To help avoid injury:
Wear gloves when connecting and
disconnecting hydraulic hoses and wait until machine has
cooled before touching hydraulic components.
2
1
3
t35om011w.eps
2
1
3
