C6830A
v1.0, C6830B V1.0
High efficiency wide input voltage
PFC programmable Charger
90V~265VAC input
For 16S LiPo,18S LiFe,24S LiTo battery
1~30Amps 1500W max.
www.chargery.com
page
15
total
20
Total solution on E-Vehicle application
Chargery BMS is a successful combination with the charger C6830. When all cell voltage reach setup
value, BMS communicate with charger, the charger continue to charge at a smaller current rather than
stopping charging.
It is very important at large current charge application. Because Start and Stop charging repeat by
Close or Open relay or MOSFET, not only cause battery voltage fluctuation at a large range, shorten
mechanical switch or electronic switch life, but also extend charging time notably.
Chargery BMS and charger as a total solution can charge and monitor each cell voltage, temperature,
charge and discharge current, short circuit even cell voltage difference, and charge each cell to any
voltage you want, such as you can set up the charge terminal voltage 3.85V per LiPo cell, when charge
is done, the battery pack will be storage at safe status,
NOTE
Chargery charger decrease charge current according to “Over Charge Protection (P) Voltage” on BMS
setup, so please setup the charge terminal voltage in accordance with Over Charge Protection (P)
Voltage on BMS.
